aw1500q terminals

cool thanx, im just gonna give it a shot and wire it up. Worse thing that could happen, i wire it into an 8 0hm load rather than a 2 ohm and blow my 200$ amp. Ah whatever, wish me luck lol

 
guess my subs a bit different, these are pretty heavy duty terminals. theres 2 of em (1 neg and 1 pos) on each side and each accepts around 6 gauge wire. ( I was serious though, i am just going to wire it, and hope its right)

 
The newer AW1005Q's should have a 1+ 1- written on them to signify voice coil 1 positive or two negavite.. they all should have it on there. Just look for the 2+ or 1+ or 1- same with 3+ and 4+. Some times the + is molded in the middle of the terminals.. just look at them hard and they will say unless they are used and the writing was worn off.

 
sweet thanks man, found em. Luckily i had it wired correctly so far //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif

Only abahn would do something like this. They are transparent ingravings in blue plastic. Its about 1mm deep. The first terminal i looked at, it have completly worn off.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

RogerWilco

10+ year member
Intergalactic Janitor
Thread starter
RogerWilco
Joined
Location
Detroit
Start date
Participants
Who Replied
Replies
9
Views
735
Last reply date
Last reply from
skeptikal
IMG_20260516_193114554_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0
IMG_20260516_192955471_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0

New threads

Top