I am still learning here and think I just made my first boo-boo last week. I put that MB Quart amp in my Honda going to the Focal 6x9's and my CDT components. The 6x9's are blazing away and sound just wonderfull. The CDT 5.25" mids also are booming away nicely. The CDT tweets were sounding just utterly amazing then.... pop //content.invisioncic.com/y282845/emoticons/crap.gif.7f4dd41e3e9b23fbd170a1ee6f65cecc.gif.... they stopped playing! They are out now for service but I think we found they blew. I am looking into some protection for them but don't really know what happened other than too much power going to them. I was on a quest for power up until that point. It kept responding so I kept giving it but now I have to figure out how to prevent it.
The Iridiums are for the truck listed. I am amp poor right now as I have a 800.4 and a 550.2, both by Kicker. Of those only the 550.2 qualifies for the task of powering the Iridium 6.2's but if my math is correct it will give me 205W per side @4 Ohm. The spec in their sheet says like max power of 150W and RMS of 100W. I can't/don't want to destroy another set of tweets again. The CDT's were 160 RMS and I killed their tweets with 250W. I need to figure this out before I F-up again.