Another "What installation items do I need?"

[crfracer290 10+ year member]

Ok I am getting prepared to install my first system and need to order all the wiring and such.

My components are

1 Fi Q 12"

ZX1000.1 For sub

Kenwood X990

Rainbow SLC 265

zx350.4 for speakers.

I am also planning to do the Big 3.

So what all will I need, down to every screw, to do installation with this stuff?

Thanks.

Click to read more...

 

[Atimm693 10+ year member]

1/0 wiring kit, 5ft of 4 awg, a dist block, say 10 ft of 1/0 for big 3, say 8 1/0 ring terminals, 1 4 awg ring terminal, one 4ch or 2 ch 6 meter or so RCAs depending if youre using rear fill, 100 ft of 16 awg speaker wire to be safe, maybe 50 ft depending on where you mount the comp amp, 2 ch 6m RCA for subs, and maybe some extra ring/spade terminals and crimps plus some electrical tape to make sure. Maybe some split loom and zip ties to make it real neat. Sand paper to sand off your grounds, self tapping metal screw for ground, 8 hex key bolts and t-nuts for amp, although you dont have to use these, just about any screw will work. Allen wrenches for dist block and fuse holder.

And remember its almost always better to have to much than too less. //content.invisioncic.com/y282845/emoticons/wink.gif.608e3ea05f1a9f98611af0861652f8fb.gif

 

[crfracer290 10+ year member]

Will I need new batter terminals? A fuse or anything?

 

[blackbonnie 5,000+ posts]

yes

 

[crfracer290 10+ year member]

So I will need a fuse/fuse holder for up by the battery, then the stock fuse that came with my zx1000.

 

[blackbonnie 5,000+ posts]

yes

 

[Atimm693 10+ year member]

The fuse/fuse holder should come with the amp kit, but you really should get another for the alt to batt + big 3 run.