amp

  • 1
    Participant count
  • Participant list

boat daddy

Junior Member
3
0
tn
I HAVE A 2 CHANNEL AMP THAT I'M TRYING TO HOOK UP TO MY REC.I HAVE KNOW PAPER WORK ON WHERE THE WIRES GO HERE'S WHAT I GOT

LEFT CH SP NEG

LEFT CH SP POS

RIGHT CH SP NEG

RIGHT CH SP POS

LEFT SIGNAL IN NEG

LEFT SIGNAL INPOS

RIGHT SIGNAL IN NEG

RIGHT SIGNAL IN POS

ALL I WANT TO DO IS HOOK IT UP TO MY SPEAKERS FRONT AND REAR PLEASE HELP ME THANKS

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Subs play to the beat with gain low but if I turn it up my subs play loud unwanted never ending bass that is constant and wont stop until I turn...
0
29
You have a blown cap in the amp more than likely. Had the same thing happen to a soundstream amp.
1
42
Getting a good voltage reading does not mean good power transfer. You could read 13.8v out of a 24 AWG wire. Recheck your amplifier's ground and...
2
229
No need to bypass the amp. Most use an LOC that takes the full amped signal and turns it into a flat RCA level signal. Here is the newest I have...
2
432

About this thread

boat daddy

Junior Member
Thread starter
boat daddy
Joined
Location
tn
Start date
Participants
Who Replied
Replies
0
Views
422
Last reply date
Last reply from
boat daddy
445981256_3731324230470906_9081536917273579948_n.jpg

Decebal

    Jun 10, 2024
  • 0
  • 0
445387485_1610561083127261_6762343569694877677_n.jpg

Decebal

    Jun 10, 2024
  • 0
  • 0

New threads

Top