amp.
- Thread starter <kenwood kac-1021>
- Start date
- Replies 1
- Views 1K
-
1Participant count
-
Participant list
Activity
No one is currently typing a reply...
Similar threads
Also, it depends on the type of wire they installed. Copper will carry a lot for power than aluminum. How much power is your US Acoustic amp...
- Started by Speedyed
- Amplifiers
Subs play to the beat with gain low but if I turn it up my subs play loud unwanted never ending bass that is constant and wont stop until I turn...
- Started by Adam Spiekerman
- Subwoofers
What amp/make and model and what sub/make and model. What HU being used?
- Started by Adam Spiekerman
- Subwoofers
This is what you need-
- Started by cdreece
- Wiring, Electrical & Installation
Getting a good voltage reading does not mean good power transfer. You could read 13.8v out of a 24 AWG wire. Recheck your amplifier's ground and...
- Started by chris123
- General Car Audio
About this thread
- Start date
- Participants
- Who Replied
- Replies
- 1
- Views
- 1,487
- Last reply date
- Last reply from
- BigAudioJoe
New threads
-
Has anyone used DataSat Amplifiers?I have a DataSat home theater system in my media room and I...- Started by Steve IZZI
- Replies: 1
-
I need Help picking the right amplifierAny recommendations for a 5 channel amp that has a 4 ohm f/r...- Started by Zach H
- Replies: 5
-
Advice: will I have enough high frequency quality / volume?I am planning out a system for my ‘04 Ram 1500 with the...- Started by Adam LaFountain
- Replies: 0
-
RCA output questionMy son is wanting to add a 4-channel amp to power his door...
- Started by RGKeller
- Replies: 2
-
Need Help with 4 Channel amp's sound qualtiy diminishing at higher volumesHello Everybody, Due to an incorrect install from a local...
- Started by Speedyed
- Replies: 3