amp???

  • 2
    Participant count
  • Participant list
You can do either. I had a pair of the perfects a while back. I was giving each about 500w from a RF BD1000.1. I also was using a RF 800.4 to run my components up front.

For the perfects I would reccomend a class d amp. They are very efficient as compared to normal a/b amps. But they are only meant for subs. Plus you can get them pretty cheap. I would also reccomend getting a amp for your highs to help balance the output.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Getting a good voltage reading does not mean good power transfer. You could read 13.8v out of a 24 AWG wire. Recheck your amplifier's ground and...
2
210
No need to bypass the amp. Most use an LOC that takes the full amped signal and turns it into a flat RCA level signal. Here is the newest I have...
2
412
It would also be easy to add an equalizer to have individual rca inputs for all of the channels. A decent one can be had for less than $40...
6
494
  • Locked
NVX MVPA1 Best tiny amp Installed a bunch, but have one pushing a sealed 12 @ 2ohm in my daily beater Can bump it all day long and barely gets...
4
787

About this thread

Philizdaman

Junior Member
Thread starter
Philizdaman
Joined
Location
Louisiana
Start date
Participants
Who Replied
Replies
1
Views
1,667
Last reply date
Last reply from
ramos
20240604_170857.jpg

metalheadjoe

    Jun 5, 2024
  • 0
  • 0
Screenshot_20240605_200209_Adobe Acrobat.jpg

Dylan27

    Jun 5, 2024
  • 0
  • 0

New threads

Top