amp works but power indicator don't light up? someone help?

  • 2
    Participant count
  • Participant list
Amp works but power indicator is off? For some reason this just came to mind, I haven't noticed that light on in a while but the amp works, other problem is it goes into protection mode.

Rockford punch 450. 4 , got voltage to both remote and power on amp. All fuses have continuity

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Getting a good voltage reading does not mean good power transfer. You could read 13.8v out of a 24 AWG wire. Recheck your amplifier's ground and...
2
158
No need to bypass the amp. Most use an LOC that takes the full amped signal and turns it into a flat RCA level signal. Here is the newest I have...
2
352
It would also be easy to add an equalizer to have individual rca inputs for all of the channels. A decent one can be had for less than $40...
6
470
  • Locked
NVX MVPA1 Best tiny amp Installed a bunch, but have one pushing a sealed 12 @ 2ohm in my daily beater Can bump it all day long and barely gets...
4
756
Amp
This tested well on youtube - not familiar with the brand but it is a pretty standard china build house amplifier...
5
551

About this thread

beginner

Member
Thread starter
beginner
Joined
Location
crazy world
Start date
Participants
Who Replied
Replies
1
Views
554
Last reply date
Last reply from
los33
20240604_170857.jpg

metalheadjoe

    Jun 5, 2024
  • 0
  • 0
Screenshot_20240605_200209_Adobe Acrobat.jpg

Dylan27

    Jun 5, 2024
  • 0
  • 0

New threads

Top