I just bought a L7 15 and a 1200.1 CX it has 4AWG wire and Yellow top. The sub played for a few mins and the went into PRT mode and has come out since. I'm only getting 4.5 - 4.9 volts at the amp but unplugged I'm getting full power. Any idea what's going on?
-
1Participant count
-
Participant list
Activity
No one is currently typing a reply...
Similar threads
Subs play to the beat with gain low but if I turn it up my subs play loud unwanted never ending bass that is constant and wont stop until I turn...
- Started by Adam Spiekerman
- Subwoofers
You have a blown cap in the amp more than likely. Had the same thing happen to a soundstream amp.
- Started by Adam Spiekerman
- Subwoofers
This is what you need-
- Started by cdreece
- Wiring, Electrical & Installation
Getting a good voltage reading does not mean good power transfer. You could read 13.8v out of a 24 AWG wire. Recheck your amplifier's ground and...
- Started by chris123
- General Car Audio
No need to bypass the amp. Most use an LOC that takes the full amped signal and turns it into a flat RCA level signal. Here is the newest I have...
- Started by William Melcic
- General Car Audio
About this thread
New threads
-
FOR SALE BNIB: NVX XCAP10HProduct Details: NVX Digital 10 Farad Hybrid Capacitor (Cap)...
- Started by AnthonyO
- Replies: 0
-
diff problemHi everyone! Some months ago, my subwoofer started doing...- Started by Decebal
- Replies: 0
-
unwanted loud constant bass when i turn up my gain on my ampSubs play to the beat with gain low but if I turn it up my...
- Started by Adam Spiekerman
- Replies: 0
-
unwanted loud constant bass when i turn up my gain on my ampSubs play to the beat with gain low but if I turn it up my...
- Started by Adam Spiekerman
- Replies: 1
-
Thoughts Before I BuyFound this on Facebook marketplace for only $100. Guy says...
- Started by Blackout67
- Replies: 3