Alpine PDX F6 and bridging

[RJ_22 10+ year member]

Ok, I have an alpine pdx f6 4 ch, and i'm looking to bridge the amp. Right now, I have the front ch running my components, and the rear powering a small sub. But I would like a little more on the sub ch. Possibly more on the components. I looked at the manual and it says I need y splitters to bridge it. But when I asked alpine to explain this process better, they messed it up even worse. So here I am. Do I need 1 male/2 female splitters or vice versa? How would I plus them in to get the sound I would like?

Click to read more...

 

[LosIsATool 5,000+ posts]

You are already using all the channels.

 

[RJ_22 10+ year member]

You are already using all the channels.

I understand that. But according to this: http://support.alpine-usa.com/products/documents/OM%20PDX-F6_F4.pdf I can bridge the amp. Im trying to do that, but I'm trying to understand it first.

 

[LosIsATool 5,000+ posts]

You can but you can only use it for either sub IF THE LOAD WORKS. or the speakers. Not both.

 

[RJ_22 10+ year member]

You can but you can only use it for either sub IF THE LOAD WORKS. or the speakers. Not both.

I understand that also. Im just asking how to wire it. Which splitter to where kind of thing.