Sleeklsc
5,000+ posts
CarAudio.com Veteran
Never dealt w/ cca in all my years in ca. Would some Cadence cca 4awg be enough for my Power Acoustik a2400db. Amp actually puts out roughly 1300 rms@ 1ohm (guestimate). The amp has a 4 awg input, the wire will be about 13ft long. This will be replacing ofc 2awg.
Why I want to downgrade:
A month or 2 back I had an issue with my rearview falling off and taking a chunk of glass w/ it, so I HAVE to simmer down my stereo in fear of it happening again. New windshield has been installed and the rv has been fine thus far. I already sold my 15's and am currently running only 1 of my 2 2007 type r's @ 2 ohm. I'll be hooking the other one up (Will then be at a 1ohm load) since it's already in the box, but the amp will be dialed down. Just don't see the point of having both back there with only 1 hooked up. Eventually I plan on 1 sa12 or a 2012 Type r.
So would it be enough?
Why I want to downgrade:
A month or 2 back I had an issue with my rearview falling off and taking a chunk of glass w/ it, so I HAVE to simmer down my stereo in fear of it happening again. New windshield has been installed and the rv has been fine thus far. I already sold my 15's and am currently running only 1 of my 2 2007 type r's @ 2 ohm. I'll be hooking the other one up (Will then be at a 1ohm load) since it's already in the box, but the amp will be dialed down. Just don't see the point of having both back there with only 1 hooked up. Eventually I plan on 1 sa12 or a 2012 Type r.
So would it be enough?
Last edited by a moderator: