I have 4 10" Planet Audio Zetar's that are Single 4-Ohm. They were ran off my Brutus 1206D and then my Sundown SAZ1500 in a sealed box (1 cf per sub). They handled everybit of the power from both amps with about 3/4 gain. (I would not recommend that much in a ported box though) They perform very nicely with about 250 - 300 watts each.
I am asking $110 plus shipping all four subs. I can divide into pairs if somebody wants.
Next, I have a Kenwood KAC-X301T 2-channel amp.
Specs are as follows:
2 ohms: 196 watts x 2 @ 14 volts
4 ohms: 142 watts x 2 @ 14 volts
Bridged: "In a bridged configuration, the KAC-X301T produced 466 watts into our 4-ohm reactive load and a mere .02% THD+N"
All of these were bench tests, not just manufacturers numbers. Here is the review that carsound.com did:
http://www.carsound.com/review_archive/amps/kac-x301t.html
I am asking $90 plus shipping for the Kenwood.
Last, I have a Clarion APA4400G (4 channel)
This amp is BIG, it is about 15" x 15". It drove my 4 10" very nicely when I had it bridged at 2-Ohms x 2. It gives out about 250w x 2 (at 2 ohms). The fan kept it cool and it NEVER got hot even with the subs at full tilt.
The specs are as follows:
APA4400G
• 100W x 4 Channel Amplifier
• Maximum Power Output 700 W (175 W x 4)
• Continuous Average Power Output 400 W (100 W x 4 into 4 ohms 20Hz-20kHz @ 0.02% THD) • Typical 2-ohm Stereo 130 W x 4 @ 0.2% THD
• Typical Bridged Power 250 W x 2 @ 0.2% THD
• Dynamic Output Control Bass Extender Control 0-12dB
• Adjustable 4-Channel 50Hz-200Hz, 24dB/oct. High/Low Pass Crossover
• 2-Channel Non-Fade Line-Level Output
• Mixed-Mode Operation
• Bridgeable 4-, 3-, or 2-Channel Operation
• Pulse-Width Regulated MOSFET Power Supply
I am asking $100 plus shipping for the Clarion
Thanks for looking, feel free to ask questions
Cody
I am asking $110 plus shipping all four subs. I can divide into pairs if somebody wants.
Next, I have a Kenwood KAC-X301T 2-channel amp.
Specs are as follows:
2 ohms: 196 watts x 2 @ 14 volts
4 ohms: 142 watts x 2 @ 14 volts
Bridged: "In a bridged configuration, the KAC-X301T produced 466 watts into our 4-ohm reactive load and a mere .02% THD+N"
All of these were bench tests, not just manufacturers numbers. Here is the review that carsound.com did:
http://www.carsound.com/review_archive/amps/kac-x301t.html
I am asking $90 plus shipping for the Kenwood.
Last, I have a Clarion APA4400G (4 channel)
This amp is BIG, it is about 15" x 15". It drove my 4 10" very nicely when I had it bridged at 2-Ohms x 2. It gives out about 250w x 2 (at 2 ohms). The fan kept it cool and it NEVER got hot even with the subs at full tilt.
The specs are as follows:
APA4400G
• 100W x 4 Channel Amplifier
• Maximum Power Output 700 W (175 W x 4)
• Continuous Average Power Output 400 W (100 W x 4 into 4 ohms 20Hz-20kHz @ 0.02% THD) • Typical 2-ohm Stereo 130 W x 4 @ 0.2% THD
• Typical Bridged Power 250 W x 2 @ 0.2% THD
• Dynamic Output Control Bass Extender Control 0-12dB
• Adjustable 4-Channel 50Hz-200Hz, 24dB/oct. High/Low Pass Crossover
• 2-Channel Non-Fade Line-Level Output
• Mixed-Mode Operation
• Bridgeable 4-, 3-, or 2-Channel Operation
• Pulse-Width Regulated MOSFET Power Supply
I am asking $100 plus shipping for the Clarion
Thanks for looking, feel free to ask questions
Cody
