2 Eclipse SW8200's + 1 Eclipse DA7122 = good?

[m48xhp 10+ year member]

the website and their spec sheets say 3 ohms and 4 ohms on the same page, so I dont know what number to really look at. If I were to get 2 of these and a DA7122 (1200x1@2) then id think it would probably do 1500-1800@1.5 ohms, but I dont know how safe that amp would be at 1.5 ohms. however at 2 ohms, it would be great. If you know for sure the ohm load of 2 of these subs parallel can you post it for me. and if it is below 2 ohms, will the amp be safe to dip below to 1.5?

and finally does anyone have a good review on these in a saled box for sq and spl?

thanks

*yes i searched*

Click to read more...

 

[luvinthebass 5,000+ posts]

if ya dip it below that your amp will get hot and might shutdown

 

[supa_c 5,000+ posts]

It wont even come close to 2ohms.

Music is so transient that it never stays constant unless you are playing tones

 

[m48xhp 10+ year member]

It wont even come close to 2ohms.Music is so transient that it never stays constant unless you are playing tones

i understand that part, but if itll bring the average down, i dont want it to hit a level too low.

and do you mean it wont come close to 2 ohms by it will be higher than that so im ok, or it will be lower so its worse?

 

[supa_c 5,000+ posts]

it wont drop that low, you will be fine.

 

[luvinthebass 5,000+ posts]

your good to go //content.invisioncic.com/y282845/emoticons/biggrin.gif.d71a5d36fcbab170f2364c9f2e3946cb.gif

 

[m48xhp 10+ year member]

as I posted in the other 8200 thread, the eclipse tech i emailed said I cannot ( or i guess should not) do this. I am assuming because of the ohm load. Should I trust him more? or is he just playing it safe, or does he just not really know what he is talking about?

 

[supa_c 5,000+ posts]

Tell him to quit being stupid.

You are fine