2 dd 2512s on a saz2500

[Haystak 10+ year member]

Right now their in a fiberglass box and wired at 4 ohm..they sound good but seem like they could be louder. What my question was, if I turned the gains all the way down on the amp and just used my setting on my HU could I wire them to 1 ohm? Or would it be too much power...I know their 800 rms, but I also know dd under rated their stuff.

Click to read more...

 

[THATpurpleKUSH 5,000+ posts]

So wait you are asking if gain settings on the amp and some random setting on the headunit will change the nominal impedance?

 

[RangerDangerV2 5,000+ posts]

set the gain properly.

 

[drockstar 10+ year member]

Right now their in a fiberglass box and wired at 4 ohm..they sound good but seem like they could be louder. What my question was, if I turned the gains all the way down on the amp and just used my setting on my HU could I wire them to 1 ohm? Or would it be too much power...I know their 800 rms, but I also know dd under rated their stuff.

Very nice amp. I wish I had your dilemma... haha.

You will be fine. Set your gains correctly, make sure you have good electric going into it, and don't abuse it.

 

[Haystak 10+ year member]

thank you, its actially only my 3rd system..my 1st was 2 pioneer tsw304dvc's on spl 2000...then saz2500 on 2 rf t2d415s (my saz blew them like they were nothing) and now im with 2 dd 12s i got from nbugart (recommended seller btw) and another thing is..i have the subs wired at 4 ohm..and when i turn up the gain/sub freq/bass boost/lpf anything on my amp it doesnt sound like its even making a dif. i had alll my gains all the way down and it sounded the same as all gains at 20% and 40%