2 channel amp and component ohm loads?

[mark871214 10+ year member]

How do the ohm loads work for 2 channel amps and components speakers? I just found out my g/f is getting me a sundown 100.2 for christmas, so im gonna have to use that for my comps. It says it does 100 x 2 at 4 ohms and 200 x 2 at 2 ohms. Ive been looking at either some Morel Tempo 6's or ID CTX65's, and these are both 4 ohms. I guess its just the 2 channels thats confusing me.

Click to read more...

 

[dumple 5,000+ posts]

one channel for left other for right

 

[lyttleviet 10+ year member]

You'll get 100x2... If she gets you a 4 channel, you can bridge it for more power //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif.

 

[cbrei1023 10+ year member]

I dont want to thread jack but this might be useful for the OP as well. Could you run two sets of components paralel and use that amp at 2 ohm? Would this hurt the crossovers?

 

[mark871214 10+ year member]

You'll get 100x2... If she gets you a 4 channel, you can bridge it for more power //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif.

Would 100 watts to each not be good enough for either the ID CTX or the Morel tempo 6?