(2) 15" fi btl

[ganesh134 10+ year member]

Need help with deciding on building enclosure for (2) 15" FI BTL.

This is the amount of room i would like to use but if this is not good, give me some recommendation.

Width = 36" (Max width)

Height = 20"

Depth = 20"

Would be sound better if the sub face up or sub face back.

All of this is going inside a SUV.

Click to read more...

 

[hrtbrk1 5,000+ posts]

sub up port back...thats what people always tell me...dimensions are quite small...

 

[ThatChevyGuy 5,000+ posts]

**** you have more room than that to work with...

 

[CobraStang98 10+ year member]

Doesn't look like you have enough room to properly port 2 15" BTLs.

Like the above poster said i'd say minimum would be like 3ft3 per sub ported.

 

[ganesh134 10+ year member]

I can not change the width at all because of the location of the wheel.

If i move the height and depth

Height = 22"

Depth = 22"

Is that better. Just a bit over ~7 cube feet.

 

[mazzasec 5,000+ posts]

HEHE My BTL's

I had mine in a box

45w 18h 20d subs up port up and can do a 150.0@45hz sealed on the dash!

 

[ganesh134 10+ year member]

If the above dimension are small. What are your recommendations? The max width is 36" due to wheel. I would like to keep it under height under 24" but if i need to go higher, i would go. I will re-measures and check the max dept. I believe it is around 26 or 28"

 

[pman44 10+ year member]

HEHE My BTL's

I had mine in a box

45w 18h 20d subs up port up and can do a 150.0@45hz sealed on the dash!

I think I saw your youtube vid. "Batteries up under this b*tch!" haha. Skating rules! I got my board in my car at all times...you never know when you might pass by a sick spot.

Yea, sick setup you got there.

To the OP. What car do you drive where the wheel wells are so close to each other?

 

[ganesh134 10+ year member]

I think I saw your youtube vid. "Batteries up under this b*tch!" haha. Skating rules! I got my board in my car at all times...you never know when you might pass by a sick spot.
Yea, sick setup you got there.

To the OP. What car do you drive where the wheel wells are so close to each other?

01 Pathfinder. I wish the wheel wells were just 6" - 10" apart. I would be a perfect setup.

 

[hrtbrk1 5,000+ posts]

uh yeah remeasure and let us know

 

[mazzasec 5,000+ posts]

Get someone to design a box with your max dimesions so you know how much you got! You should be able to give them atleast 3.5 cubes each which is what mine had.

 

[ganesh134 10+ year member]

I just check the measurement.

Width = 36"

Height =24"

Depth = 30"