18" RE SX on a bx1605d question

[coolahan 10+ year member]

Okay so the 18" RE SX is dual .7 ohms.. wiring it in a series gives me a 1.4 ohm load (correct?)... would that load run fine on my bx1605d ? Its 1ohm stable but I didn't know if it not being 1.0 ohms would matter..

Click to read more...

 

[90accordman 5,000+ posts]

it will be fine

1ohm stable so it should run just fine at load higher then one ohm

 

[coolahan 10+ year member]

it will be fine1ohm stable so it should run just fine at load higher then one ohm

thx bro you're always a help... //content.invisioncic.com/y282845/emoticons/biggrin.gif.d71a5d36fcbab170f2364c9f2e3946cb.gif

 

[90accordman 5,000+ posts]

np

 

[mannyb18b]

You get a custom VC config?

 

[mannyb18b]

^obviously

^Shut up I wasnt talking to you!!

 

[90accordman 5,000+ posts]

somethign get deleted or ya talking to yourself bro?

 

[mannyb18b]

Ive gone craaaaaaaaazy...........for Q's //content.invisioncic.com/y282845/emoticons/wink.gif.608e3ea05f1a9f98611af0861652f8fb.gif

 

[coolahan 10+ year member]

would the SX 18" be fine with my bx1605d pushing it? i wouldnt be heating up the coils to much would i?

 

[Ali1 10+ year member]

You would be absolutely fine as long as you don't do clipping.

 

[mannyb18b]

I would watch your gains and set your amp to push no more than 1200 watts of clean power.

 

[coolahan 10+ year member]

I would watch your gains and set your amp to push no more than 1200 watts of clean power.

would i do that by replacing 1600 with 1200 in the setting the gain formula...

some body?

 

[matrxx dude 5,000+ posts]

You get a custom VC config?
just wat i was thinking,sx's come standard in dual 2's,now mt's come in .7 or 1.4

 

[coolahan 10+ year member]

can somebody answer that question? ^^

 

[coolahan 10+ year member]

cmon guys how would i go about limiting my amp to 1200 watts?