Skip01
5,000+ posts
Diggy
So i put it in last night at 4ohm for a bit....but annoyed me, so today wired to 1ohm
Now, my full tilt is set to around 45 out of 50 volume....when i get to about 40 it bottoms out, mechanical noise. Maybe from not breakin in or not...dk just yet
Most this video is with vol at 35
But after all that.......WOW....this thing is really soooo much more authority on the lows than i woulda thought.....its hard to explain really
When i had the BTL in at .5 in same box it was muchh louder and would not make any complaints about the power....and was nice on the lows...but the HDC its more like a wave of pressure than a musical note when it plays lows
Even at lower volume its just more feeling than the BTL, but not as loud, granted its 1ohm to .5ohm.....but again...only a few minutes of play time, still might need to loosen up a bit
Heres vid:

All just my opinion and based on my setup solely
Now, my full tilt is set to around 45 out of 50 volume....when i get to about 40 it bottoms out, mechanical noise. Maybe from not breakin in or not...dk just yet
Most this video is with vol at 35
But after all that.......WOW....this thing is really soooo much more authority on the lows than i woulda thought.....its hard to explain really
When i had the BTL in at .5 in same box it was muchh louder and would not make any complaints about the power....and was nice on the lows...but the HDC its more like a wave of pressure than a musical note when it plays lows
Even at lower volume its just more feeling than the BTL, but not as loud, granted its 1ohm to .5ohm.....but again...only a few minutes of play time, still might need to loosen up a bit
Heres vid:

All just my opinion and based on my setup solely
