Item(s) for Sale:
1. Product:
Former 15" L7 converted to a 10" round sub.
2. Specs:
D2, coil is rated to 1000 wrms, soft parts and motor will handle that without a problem. 6.6" Mounting depth
4 LAYER ROUND COPPER WIRE
Black Anodized Aluminum Former on Nomex Tape
1.75" WIND HEIGHT
3.60" FORMER HEIGHT
2.74" OUTER DIAMETER
2.58" INSIDE DIAMETER
3. Description/Condition:
Has not been powered since built! (Only very small amount of power to it to ensure it works and no coil rub).
Turned a 15" Kicker L7 motor into a round 10" with 12 spoke basket, triple spiders, firm cone, carbon fiber/kevlar 6" cap. It was a pain to make because I have to mill the basket to fit, trim the spiders, trim the cone, nothing fit right lol.
Only parts that were used previously here are the motor (obviously), and the rubber gasket.
4. Price: I would like to get $160 plus actual shipping. I have more money in it than that I just wanted to see if I could do this, and it was a success. :
5. Pictures:
[br][/br]
[br][/br]
[br][/br]
[br][/br]
[br][/br]
[br][/br]
[br][/br]
[br][/br]
[br][/br]
[br][/br]
[br][/br]
(List pictures in this section, 1st picture should be your username/date if you have less than 10 positive feedbacks with the i-Trader system or less than 10 references that you have sold to in the past. (These must be listed in your signature, or a link provided to a feedback thread listing these references)).
1. Product:
Former 15" L7 converted to a 10" round sub.
2. Specs:
D2, coil is rated to 1000 wrms, soft parts and motor will handle that without a problem. 6.6" Mounting depth
4 LAYER ROUND COPPER WIRE
Black Anodized Aluminum Former on Nomex Tape
1.75" WIND HEIGHT
3.60" FORMER HEIGHT
2.74" OUTER DIAMETER
2.58" INSIDE DIAMETER
3. Description/Condition:
Has not been powered since built! (Only very small amount of power to it to ensure it works and no coil rub).
Turned a 15" Kicker L7 motor into a round 10" with 12 spoke basket, triple spiders, firm cone, carbon fiber/kevlar 6" cap. It was a pain to make because I have to mill the basket to fit, trim the spiders, trim the cone, nothing fit right lol.
Only parts that were used previously here are the motor (obviously), and the rubber gasket.
4. Price: I would like to get $160 plus actual shipping. I have more money in it than that I just wanted to see if I could do this, and it was a success. :
5. Pictures:
[br][/br]
[br][/br]
[br][/br]
[br][/br]
[br][/br]
[br][/br]
[br][/br]
[br][/br]
[br][/br]
[br][/br]
[br][/br]
(List pictures in this section, 1st picture should be your username/date if you have less than 10 positive feedbacks with the i-Trader system or less than 10 references that you have sold to in the past. (These must be listed in your signature, or a link provided to a feedback thread listing these references)).
Last edited by a moderator:
