1 ohm stable?

[phillipcyoung 10+ year member]

This may be a stupid question, but is this amp bridgeable and stable if i run it at 1 ohm?

Kicker ZX1000.1 Specs and Features:

o Remote control knob with 25 ft. cable

o Kicker EQ boost up to 18db

o 20hz - 200khz frequency response

o 250mv - 10v input sensitivity

o >95db or better signal to noise ratio

o Selectable low pass crossover

o Subsonic filter @ 25 Hz 12 db per octave

o 24 DB per octave 50 – 200hz adjustable crossover

o 500Watts x 1 RMS 4 ohms CEA rating

o 1000 Watts RMS @ 2 ohms

o Soft start circuit Protection circuit

It is a kicker mono so I would think it would be but it doesn't say anywhere in the specs

Factory Recertified

Click to read more...

 

[photocrazy8 10+ year member]

no, stable at 2 ohm only, some people run them at 1 ohm and have no problems, other people run them at 1 ohm and fry them...

 

[helotaxi 5,000+ posts]

Also it's a mono amp so you can't bridge it. That requires 2 channels.

 

[phillipcyoung 10+ year member]

what would be a solution? step up to more watts or get something along the same lines that is 1 ohm stable?

 

[Louisiana_CRX 5,000+ posts]

A Kicker SX 1250.1 is one ohm stable