speakers 4 channel

Hello, I have two Kicker 6x8" CS series speakers that are rated at 75 watts RMS 225 watts peak, and two Kicker 6x9" CS series speakers that are rated at 150 watts RMS and 450 watts peak. My question is how do I properly power all four speakers with a single 4 channel amp? They are 4 ohm speakers...

I have a KICKER - CX 360W Class AB Bridgeable Multichannel Amplifier with Variable Crossovers KICKER - CS Series 6" x 9" 3-Way Car Speakers with Polypropylene Cones 4 Ohms in the rear Kenwood - 6-1/2" 2-Way Car Speakers with Polypropylene Cones 4 Ohm in the doors and it was wired by Best...

I'm replacing my stock door speakers with something new. I'm putting in two 15s so I'm looking for something which can be loud enough to hear well. I was recommended these elsewhere: http://www.amazon.com/Infinity-Reference-6032cf-6-5-Inch-High-Performance/dp/B002BZFSYA...

I just recently bought 2 pairs of Pioneer 4 way 6 1/2" speakers to replace the factory speakers in my Jeep. I have thought about amping them but I have never amped just the speakers before. I was wondering if I could get some advice or some knowledge about what to look for amp wise or if it is...

i am currently running 4x6s in the front of my vehicle and 6x9s in the rear , the 4x6s are 2 ohm svc and 6x9s are 4 ohm svc , both sets are begin run off a kickerzx350.4 which puts out 60rms x4 at 4 ohms and 90rms x4 at 2 , each speaker is running off a seperate channel , my question is that...