overheating

Be honest... is my amp just ****** and can't produce enough power for my subs, or am I doing something wrong? My amp is a Crunch powerzone pzi 2250 1000 watt max 2 channel 250watt rms per channel (bridgeable @ 4 ohms). My subs: 2 Pioneer TS-W303R 12" 250 watt rms 1200 watt max 4ohm SVC. I...

My amplifier overheats when I have it bridged to my Rampage subs. The subs are 2 12" in a sealed box. The amplifier itself is a 4 channel and has two 25 amp fuses, so about 500 watt RMS right? I think the max on the amplifier is 1600 watts it said? The subs are 1200 max. When the subs are...

Hi everyone, I recently had two JL HD900/5 installed to replace my old Memphis amp. While I had this done, I also upgraded my electrical by having an 80 amp hour Shuriken battery installed under the hood; the ground wires for the battery and engine were doubled up as well as the alternator to...

I have an MTX RT2400X Road Thunder amp which appears to have a short in it somewhere. I originally turned it on without hooking it up to any subs, within minutes, it was hot to the point it was burning my hand. i disconnected it from the power, and when i reconnected it, without even turning it...

I just recently bought 2 12'' orion xtr subs, new in a ported box. Then decided to get a Orion amp, I found a old school Orion 4004 on craigslist for dirt cheap , hooked it up and works great, I wired both subs bridged on the rear channels and had the 4 guage power/ground wire ran...