bridging

Sony xplod XM-GTR6001 So Sony manuals FAQ’s, and knowledge base’s say that to bridge a 2 channel amp for 1 single SVC sub,is to just use the + and - from one channel.. I have always thought that you take + from channel 1 and - from channel 2 Can anyone confirm the right way I also wanna know if...

Hey everyone, I'm new to car audio systems and I bought a First Austria FA-4400 amplifier 1 × 14 Watts channel 1 at 4 Ohm 2 × 13 Watts channel 1 + 2 at 4 Ohm 4 × 13 Watts channel 1 up to 4 at 4 Ohm I was also given Coustic CF1044 Diameter (inch) 10 Max Power(W.) 800 RMS Power(W.) 400 Number of...

Hi, I just want to ensure that my understanding of amp bridging is correct. I plan on getting the following amp: Pioneer GM-D8604 Class FD 4-Channel Bridgeable Amplifier - Pioneer Amplifier - Amplifiers&Cable | Sound Tech New Zealand. If I am correct I should be able to bridge 2 channels...

Hi, I am looking for amp solutions to power my JBL ms-62c components and 10w1v3-4 sub. one 4-channel amp is cheap and less stress on my electric system. However, some say that the bridged 2 channel does not sound clear even with the on board crossover and its better off to get two separate amps...

I was wondering if bridging a 4-channel amplifier to 2-channels at 4ohms is going to cause any noticeable distortion or overheating problems. I've been looking at the PPI P900.4 to drive my JBL C608GTI MKII component system. I know it's a little overpowered but I've heard these JBL's can take...

Does a 4-channel amp produce have any noticeable distortion or overheating problems when bridged into two channels at 4ohms? I've been looking at the PPI P900.4 or the to drive my JBL C608GTI MKII components. Yes I know that's a little overpowered but from what I've read these JBL's can take...