Recent content by ZO6killinsbf

Whenever I fiberglass I just throw a 60 grit flapper disk on my grinder and touch it up. Works crazy fast.

Looks good. The 4 doors already have so much more room than the 2 doors it's rediculous.

OK, I'm going to build a new box for 2 12's in the next few weeks. Should I go port back/subs up, port up/subs up, port side/subs up, port side/subs back? Or any variation ya'll recommend?

**** iroc2nv, I was just in Madison like 2 weeks ago! Whats up!?

I'm wanting to upgrade this system and build a false floor to hide the amps and wires, I hate how it's all spread out right now (PPI amp is behind the box). Would adding 2 more 8's make a significant improvement or should I shoot for a pair of 12's? I normally listen to bass heavy music and...

Awesome work! Those respirators have particle filters that replace those chemical filters. Pink disc things.

I hear ya, it's hard to spread my money out when the Mustang takes all of it! There are some impressive builds on here, it's always a learning experience to me.

Yo! Whats up homie? Fancy seeing you over here.

Maybe, how much?

If anyone remembers my previous build for a budget SQ-ish system in an S-10, I'm back! http://www.caraudio.com/forums/car-audio-build-logs-cars-trucks-suvs/499068-s10-cheap-sg-system.html I sold the S-10, striped as many parts off as I could before hand and put them all on my new Blazer. I had...

Tuned in as well.

OK, I went back and re-entered the sub parameters but this 34Hz tune came out to peak at 45Hz, is that ok?

This?

I'll have to re run the program, my wife shut down the computer and I'm sure I didnt save everything. DOH!

Ok, I followed the tutorial and I thought all was going good until I checked the transfer function magnitude in WinISD. (2) Infinity Reference 1262w's Power Handling, RMS 300 W Frequency Response 23Hz - 400Hz Nominal Impedance 2 or 8 Ohms Sensitivity (2.83V @1m) 96 dB Mounting Cutout...