Recent content by wildboys

Which one of these head units is better?Kenwood XXV-01D or kenwood KDC-X990.Are the both about the same.What seperatesone from the other thanks.

Has anyone hear used the Boston Acoustic Neo Type-MImaging System?If so what was your impression of the system.It is also hard to find someone that sells them.

No the tweeters are mounting in the sail which is shaped like a boat sail.look right above the top of the door above it is on the same plane as the right side mirror.It is not in the door.If you look closely you will see the round tweeter on the black trianglar sail.

The mids are in the door and the tweets are in the window sails on both sides.

I put the tweeters in the sail of the windows

I just had a set of Boston Acoustic pro 60 installed.These speakers are amazing.The clarity and the detail is unbelievable.At any volume level they are clear and precise.I am sending 300rms x 2 to the comps and they take it like a champ.They are rated at 125rms.i must say this is a very...

Does anyone know where you can buy Boston acoustics Neo Tye-M imaging tweeter system.I am having a hard time finding some one who sells them?

I am getting a set of Boston acoustic pro 60 Speakers installed tommorrow.I have attached a picture of how my current comps are installed.I have the mids in the door and the tweets in the window sails.Many people say i should not seperate the tweets from the mids and install the speaker in the...

If i use a 200 rms x 2 amp with a set of boston acoustic pro 60 comps will the tweeter and the midbass both be getting 200 watts?If so will this destroy the tweeters?I read on the forum that the Pros can handle 200 rms easily.Does this apply to the tweeters also?

So i just need to add another jumper positive to positive neg to neg right?I think the installer screwed me over.

TeoTorriatte in the jpg i posted the sub is only wired for 8ohms.If it is a am upset because it was professionally installed and they said it was wired for 2ohm.In the diagram link you posted looks like they wired it for an 8ohm load.Am i correct?It only has 1 jumper the diagram shows two at...

This is an alpine R dvc sub it is 4ohms.I want my amp to see a 2 ohm load.Is this the correct wiring for 2ohm load or do i have it wired for a 4ohm load thanks.If this is not correct what should i do to make it 2ohm load

I just pick up some Boston Acoustics Pro60 6.5 comps.The tweeters are connected to the mids.Should i leave them there or put them on my dash?I heard you should live them as close as possible to the mids.Any suggestions?

Is it ok to use a -10db test tone to set gain on your amp for your subwoofer?I will be using an oscope to set the gain.