Recent content by unknownmotive

Its a Profile HA1000. So would it be okay to only use one channel?

Well i have a 2 channel amp...is it okay if i only use one of the channels to power my sub? And what kinda box should i build for my sub....its a Cerwin Vega HED 10 SVC.....

??? acc?

Well the blue wire was the only non-connected wire is saw....the deck is 4-5 years old...should i just use that?

Ok so connecting it to the wire described above will be fine right?

Today I tried to install my amp, so I removed the HU which is a Kenwood KDC-215s. When i looked for the remote turn on i didnt see any wire. But i did see a wire labled as ANT CONT/P. CONT...The wire was blue with a white stripe and was not connected to anything.... IS this the remote turn on...

I have a Profile HA1000 and A Pioneer Ts-307D2..... So my amp puts out 480w RMS @ 4 ohms bridged.... If I want to put out 400w RMS@ 4 ohms do i set my gains so I get 40v [sqrt (400x4)]? I want to do this since my sub runs at 400w RMS @ 4 ohms. Can anyone run me through on how to set the gains...

Im mounting it in the trunk......

Where to ground??????

Is there suppose to be a gasket that goes between the sub and the enclosure? Does that usually come with the sub or do i buy one? I am going to install my amp behind my back seat which underneath is metal. Should i screw a piece of wood into the metal then crew the amp on to the wood or can i...

Where did you ground it?

?

???

Ok an what size screws? Should i use silicon on the seams?

So im building my first box for one Pioneer Ts1207 d2 sub. It going to be sealed since I dont have much room. It will be around 1.25 cu feet. When building the box can i use 1/2 MDF cause i have a sheet in my garage or should i use 3/4 Mdf? Do i need to add support to the box like structrual...