Recent content by thejoker989

Been out of the loop for 5 years and I have finally pieced together my system. It is going in my 2010 WRX 4dr. Going for maximum possible stealthiness. What do you guys think? Any changes to make before starting the install? Bit Ten w/ DRC PG SX1200.5 PG Ti265cs PG Ti10d4 Peerless SLS 6.5...

I have a RLP-15 D2 in mint/very near mint condition. It is too big for my car and want to downsize to a mint/very near mint RLP-12 D2 (maybe D4). Anyone interested?

Ur aux output is a low current -, so yes you will need a relay. 12v on 85 on 30, Red/White wire from alarm on 86, and solenoid + on 87

priority driver door unlock

sarcasm...

Winter mode only applies when the alarm has a thermometer which is not the case with this alarm. Another use of timer mode could be if you leave your kid in the car on a hot day and need to kick the A/C on for them every 45 minutes or so.

Its actually called Timer Mode. One of it's intended purpose is to keep the engine from freezing during a really cold day. Turbo timer allows the car to idle for a couple minutes after you take the key out. Wiki: A turbo timer is a device designed to keep an automotive engine running for a...

Ignition wires come on in the run position and hold power during crank, Acc wires come on in the acc and run position and drop power during crank. But then that leaves the HVAC which comes on in the run position and drops out during crank. Some people call it an Ignition 2 wire, and others call...

line output converter off the low level radio output = no no, line output converter after the factory amp is a much better idea

I have never seen a factory radio that has an auxiliary input on the back, even if it has the aux button or not.

newer xm and sirius units run off of 5v, so if you have one of their cigarrete lighter power adapters laying around u can use it to power your first choice. Or if you have a cigarette lighter sony psp charger, or a cell phone charger that uses mini usb (moto razr, most pocket pc's), or a...

If your worry is the lack of current then at least use a relay off of the horn wire. I think the siren wire puts out a constant +12 when the alarm is triggered, but the horn output puts out a pulsed output so the horn isnt consant, but going on and off.

Fuse Opening Time: A fuse does not blow when the current reaches its rated current. It is designed to pass its rated current without opening. A fuse will take varying times to blow under different conditions. A fuse will pass significantly more than its rated current for a very short time. It...

It will work for what its made for if it's tuned properly

problem with doing a piezo siren and a glass break sensor is the the frequency the piezo plays is the same that sets off the glass break sensor. So a warn-away chirp will trigger the instant trigger glass break sensor. Also a bypass notification will trigger the glass break sensor. The easiest...