Recent content by tdog333

Ahhh okay that makes more sense, never would have guessed. Okay so just take the blue/yellow(constant according to that link) and connect to the yellow on head unit, and then connect the grey(switched) to the red(accessory?)

Btw: vehicle is 1999 toyota landcruiser, head unit is a pioneer DEH-4300UB, but is getting replaced tomorrow with a Power Acoustik Power Acoustik PD-710B if i can figure this wiring problem out

Hey guys, I just got done installing a new 4chan amp and door speakers. I re-wired everything, ran new wires for front and rear speakers and unplugged factory amp. When i tried to turn Head unit on nothing happened. I checked the voltage on the red wire coming out of the stock harness, and there...

I'm going to install a 4chan amp later today, I have another amp for my sub's in the back with a remote wire already ran. Can i just piggyback the new REM wire onto the current one? http://s14.postimg.org/7ozah7rtt/okay.jpg My microsoft paint drawing of my question ^

Okay perfect that makes sense. Also, I was looking at the specs for my amp again and just noticed it is 2 ohm each channel and 4 ohms bridged i think? my speakers are all 4 ohm load. So will this be a problem? PRIME Amplifiers - R250X4 - Rockford Fosgate®

My setup right now is as follows : Toyota Land Cruiser 1999 SUV Rockford Fosgate PRIME R500-1 Amp Pioneer DEH-4300UB 1 Alpine SWR-1243D 12" sub Wired to 2 Ohm 500W RMS 2x Kicker KS600 installed in front doors 2x Rockford Fosgate P165 (to be installed in rear doors) Rockford Fosgate R250X4...

Okay perfect thanks for all the info! If I wanted to move the amp to the back, and run completely new wires, I could just hook up speaker wire to each speaker, and run it to the 4 channel amp, run the RCA's from the amp to the head unit right? Or do i need to use the stock wires in any way?

Okay actually Couple quick questions: 1. I am going to remove the factory amp and replace it with a 4channel. Can i just unplug the factory amp and remove it, and just leave the harnesses/cables unplugged. Then wire the 4 channel up and each door speaker to it? Or is there something on the...

alright im thinking of getting some Rockford-Fosgate-Punch-P165's (they are pretty cheap so no big deal) and a new amp to replace the factory amp. I have some questions about installing a new amp though. All the RCA's on my head unit are full, so i would have to use the pass through RCA's on...

Okay i really need to do that, I'll get it done soon. Would you reccomend replacing the rear door 6" speakers with mid bass or something? then hook to a 4chan amp replacing the factory amp?

Right now my setup is : Toyota Land Cruiser 1999 SUV Rockford Fosgate PRIME R500-1 Amp Pioneer DEH-4300UB 1 Alpine SWR-1243D 12" sub Wired to 2 Ohm 500W RMS 2x Kicker KS600 installed in front doors 2x Power Acoustik NB.2 tweeters(in the mail will be installed soon) Factory rear door...