Recent content by SoSo09

bump

Alright guys, I have an amplifier problem. Hifonics 2610D. My amplifier randomly stays ON when the car is off. I have no problem at all when the ignition is on, the amplifier runs strong. When unplugging the remote wire from the terminal, it usually shuts off on its own. Sometimes...

I'm trying to keep the budget below $150. Closer to $100 would be nicer. Just looking for some decent entry level speakers. I thought I had it narrowed down to some of the best 3. Anyone else with some input to help me with this decision?

What price should I expect to pay for those? I can't seem to find them, only the CX 64s

anyone else?

Ok, I have two 12s @ 29hz in my car that play the low lows pretty well, so rap is covered. I'm just looking for some 6.5s that will put out some better midbass for metal and other sorts of bass that the 12s roll of at. Better vocals/treble would be a nice upgrade too. At first, from reading...

Well I went ahead and designed a box. Again, any input is appreciated 40 x 13 x 19 3.6 cubes @ 35hz, without port volume 4.5 x 11.5 port, 25.25" long One quick question... One sub calls for a 4" diameter port, with 11" of length With two subs, is a 4.5 x 11.5 slot port sufficient? The...

Bump? :/ I'm wanting to build it today, and I'd rather not have to wing it and waste a bunch of MDF...

If anyone could help me in anyway of designing this box, it would be greatly appreciated. I have two RF P212S4 subs in a sealed box and i want to try them out in a shared chamber slot port box, but I've never built one. The width of the box needs to be 39.5", and can be up to 17" tall and 25"...

So, there is no way I could wire the two subs into a series of 8-ohm, then bridge it down at the amp for a 4-ohm load?

With disregard to the amount of wattage that I will be putting to my subs, I have a question about wiring. I have a 2-channel amp, and two 4-ohm SVC subs. Currently, they are hooked up in stereo, giving them each 187 @ 4-ohm. I understand the basics of ohm loads and bridging, but I'm still a...

Bump.

It helps, but it still takes a good 15+ minutes to get everything warm...

Hey whats up guys. I have an 01 Rodeo with 2 Rockford Fosgate P2 12s and a Panasonic headunit. Lately, in the mornings, when it is cold, my CDs have been skipping when the bass bumps. This is not a problem in the afternoon when its warm outside. Any ideas?