Recent content by solidcrowd

So I'm looking to port an enclosure I purchased off CL for my home audio setup. I have TWO Dayton Audio RSS315ho-44 DVC 12" HO's which will be powered by my 240wrms plate amp @ 4ohm. The enclosure is a slant(wedge 2) dual sealed enclosure with seperate chambers. Dimensions are: 34.625"W X...

bump

I've had this problem for awhile. I don't believe it's a ground issue, It does NOT happen when i turn off the head-unit manually. It ONLY happens when i turn off my car (04' Chevy Malibu Classic) and open the door. OR If i turn my car off and listen to music for awhile, eventually the car...

I have two of these sitting in my room waiting for an enclosure to go in. Would like to bump this thread for more input and also wondering what results you had or what design you went with,. Thanks

If you don't mind me asking, what cuft did you put them in and what were they tuned to? Also, how do they sound or what do they compare to? It's between these or getting my 12" AB XFL replaced..OR my 12" Si Mag Claw reconed by a local guy.

Any input would be great.. I also don't really know how to use Winsd or how to figure out the results.

Okay so I've attached a picture* of drawn to scale design I made up with the dimensions I'm shooting for. I need help finishing the design and a cut sheet would be awesome! I have TWO Dayton Audio RSS315HO 12" subwoofers that I want to put in the perfect Aeroported enclosure. I have 26-27...

No coil rub or scratching . suspensions still stiff. But yea it's dual 4ohm :/ I'll have to re-cone my blown 12" SI Mag Claw..If i'm going to recone anything, it's going to be that lol. I also have 2 brand new 12" Dayton Audio RSS315 HOs I could build a box for and install. You gentlemen...

Ya I have a suriken bt20 in the back. And ya the subwoofer is an American bass XFL wired to 2ohms. Is it possible to smoke a coil and have the subwoofer play fine (seemed to be from what I could tell)? I'll have to take it out tommorow to check more in depth

I checked the Ohms on my DMM. from the terminal on my enclosure it reads 1.1 when I keep a steady hand

I checked the Ohms on my DMM. from the terminal on my enclosure it reads 1.1 when I keep a steady hand

The blue indicator lights always stays on, I'm not sure If It has a protect mode light. I will check the coils and look for the protect mode light right now! BRB Also, I noticed the first fuse sticks out like a MM higher than the other fuses. I even swapped it out and put another new one in...

Na I haven't . I can check them but using the terminals right? They should read 2ohm or close to it right?

My amp grounds are great. I believe they are the rear struts. I don't believe I grounded my headunit correct after doing research. I just ran the ground to the black wire (ground) on the wire harness. So it's being grounded that way...should I leave it like that and run a ground wire / splice...

So recently I blew a few fuses on my alpine pdx1.1000. Also, when that happened smoke was pouring out of my port. So I tested the subwoofer on my plate amp shortly and it played fine (wasn't cranked to much). My plate amp only gave it 180wrms. I replaced the fuses on my amp an it tuns on. I...