Recent content by SirVyouup

Factory 80 amp alt. Big 3 1awg. Kinetik hc1800. 1awg lead with 250 amp fuse to distribution block with dual 100amp fuses. 2 4awg outs that lead to 2 stacked kenwood kac9105ds. Pushing 1800 watts rms at 2 ohms to a single Pioneer ts-w30002d4 1000 watt rms. Voltage dropping below 10.5 on hard...

Do you know why Ronny? I have 2 amps each amp is grounded at two different seatbelt bolts. I am having major voltage drops. Could this be why?

No HO alt. My voltage drops are going below 10.5 within a second or two after a deep note even after a full external charge on both batteries. Am i underestimating a HO alt? It just seems 2 batteries (especially the Kinetik 1800) should produce more voltage. And yea i am using bass boost @ 100%.

I am also have major voltage drops. I have the big three done, a brand new Autocraft gold up front, and a brand new Kinetik hc1800 in rear. 1awg connecting front and rear battery. the two batteries are grounded in different spots. I am running 2 Kenwood kac9105d's that are grounded where the...

How important is it to run 0awg from negative front battery to negative rear battery? An should i run my amps off of the rear negative battery terminal or ground them seperately?

The Kenwood 9105d may say 1800 watts, but the only way to get 1800 watts is to stack them and run em at 2 ohms.

I just purchased a new Kinetik HC1800 and was going to use it as my main (starter) battery. But just yesterday my original main battery died still under warranty so i go a new replacement. Its a Autocraft Gold from Advanced Auto. Will i run into problems if i decide to run both batteries...

Dude the phase should be in middle position, not 0 or 180. 0 is for the master amp and the 180 is for the slave amp when you stack them.