Recent content by shake this

Per Sundown's recommendation 0.5-0.75 ft^3 @ 35hz

I put down 3 coats of polyurethane because I was worried that it might not stick well to the MDF. However, I think I could have gotten away with just using it on any area that was actually cut. The face of the box would have been fine without any sealer, just a damp rag to pick up any dust. The...

I can promise you, the vinyl is much faster than paint.

I’ve been playing around with vinyl wrap and decided to try it as an alternative to paint, carpet or the typical vinyl. So let me know what you think. Could it replace the standards or should we leave well enough alone and stick with the common ways to dress up sub boxes? This face is...

Then you mind not want to look. LOL The only interior in the car right now is the dash, front seats and the door panels. BTW, like your 500 too, why haven't I seen it??

in the mile??? 200 in any distance is impressive, the driving experience becomes completely different once you pass 150.

got the batter mounted and finished running the wires to the back of the car, will spend tomorrow running dual 4ga from the engine bay to the trunk. Oh and just a few more pictures for you guys to show why we run slicks and need the extra weight in the back. Stock blower And the Kenne...

What can I say...he likes the look of the stock HU and who am I to judge, he's the one with a Shelby, not me. Oh and for those that worried, Ford is still using Radio Shack rejects even on 60k cars. this is what we pulled out of the back deck.

Its a beast of a car, it's putting down about 800hp to the ground right now and he's about to send it out to have the bottom end built so he can shoot for 1000hp. We are actually relocating the battery to the trunk and adding 2 12's, he's having traction issues as is so a little weight in the...

so where is the factory amp for the 6x8's, I thought the shaker 500 only had the amp for the 8" door subs (the one located in the driver kick panel). If I'm using the PXE-H660 why couldn't I pull the signal before the amp and then feed the signal back after the amp? Essentially bypassing the...

Helping a friend upgrade the speakers and adding a couple of amps in his Snake but it seems that we have run into a little glitch with the speaker wires off the HU. We will be using a Alpine PXE-H660, is it possible to use the speaker level outputs straight from the back of the deck to the...

Thanks guys, we were very happy with the way it turned out considering it was our first shot at a wedged port.

The port dimensions were just one of a few challenges we faced but nothing that a little forethought couldn’t fix. My major concern was getting port noise from the drastic angle from the slope but we were able to work it out thanks to the help of a little router magic. LOL

No need in going with a different driver, he was very happy with the sound and said the trunk space was a fair trade off.