Recent content by PJK485

Yea it sounds like a grounded speaker to me. You can also check by putting ur DMM on Voltage DC and disconnect the wires from the amp. Then put one side on positive 12v and the other side on the speaker wire. If it shows 12v then you have a grounded speaker or wire.

ugh i hate those. i would run a remote to the accessory wire behind the radio or under the dash.

did you catch the remote turn on behind the radio? where did you get the signal for the PAC piece?

My shop is looking to pick up a new line. We are trying to decide between RE and JBL. What do you guys think? Thanks in advance

Same thing just ground the wire.

Brown at the PCM, blue plug, pin 22. The PCM is located in front of the driver strut tower, above the battery cover.

yea the amp is behind the glove box. pain in the a$$ to get to. About twenty screws and the glove box comes out...not too bad after that if you know what u are doing.

alpines website lists the kca-121b for the ai-net aux in adapter for the 9886.

No it won't even power on without the brain unfortunately.

Did you turn AUX-IN on in the setup menu?

Do you have onstar or bose? If you have onstar and it is active you can use the PAC OS-2, if you have both you can use the PAC OS-2BOSE. If you have neither you can use the PAC C2R-GM24. These will allow factory amp integration. Any reputable shop should have these parts in stock. They run...

You can run the amp at 4 ohms so you don't blow those subs. Make a jumper wire and go from positive on voice coil one to negative on voice coil two. The remaining two terminals go to the amp. Do this for each sub. This will make each sub 8 ohms. Then when you connect them to the amp it will make...

It is a monoblock amp so you can hook to either set. The frequency should be set at around 80hz.

The amp is bridged internally. Just hook one woofer to one set of terminals and the other woofer to the other set of terminals. They give you two channels for wiring flexibility.

Which 9886 are you guys using cuz mine has 4V preouts and a high pass crossover.