Recent content by oc_cheby

Thanks, I wasnt sure of which power wire to match to ... power to the distro or from distro to amps. So I will be good with 8 gauge grounds coming out of the 2 amps, as long as I do go any smaller in size. Any comments on buying the wire for these short runs at HD or Lowes?

Im not too clear on what size ground wire I should use for this setup. Im hoping some of you guys and gals could clear this up for me. Im currently running a 4 gauge power wire to a 300w x 1 (2 ohm) amp for my sub. I will be adding another amp (40W × 2 - 4 OHM) for my door speakers. I bought a...

So that distro block should work ok for my simple setup ... cool. Ill most likely end up using 8 gauge for the ground on both amps since I have to buy some to run after the distro block. Thanks alot for the info everyone. OC

**Bump**

Will this distro block be ok if I want to add another amp to power my door speakers? Im running 4 gauge wire from the battery to a "300W x 1" sub amp. So Ill run the 4 gauge wire into the distro block, 8 gauge wire to each amp right. What gauge wire should I use for ground from each amp, 4 or 8...

Thanks for the info everyone ... I just ran the remote wire to the blue/white wire directly. Worked out great!

I dont think it has a power antenna. when i had it installed (before i found this forum and realized i could possibly do it myself with everyones help), all i had to get was a HU wiring kit and an antenna adapter. the installer at BB spliced all the HU wires with with the HU adapter wires i had...

when connecting the remote wire from the amp to the HU, would I "tap" into the blue/white wire or would i cut the blue/white wire coming from the HU and connect it directly and only to the amp remote wire? yeah yeah yeah, its a noob question. Thanks!!

Thanks for your input everyone. So I should be good to go if I just add some polyfill? Do you think the amp would get too hot in that space? should I give it more ventilation? The amp and storage space will be covered with a lid.

Did I leave some info out? .... Bump ....

Thanks wcarson8911.

Here is what the entire box that will go under the back seat will look like ... hopefully

Hey everyone … I’m going to build my first sealed enclosure that will be going under the back seat of a 06 Silverado Ext Cab to house one Power Reference 10" Dual Voice Coil Sub. The sub has a mounting depth of 5”. I’ve drawn it up in Sketchup but I wanted to run it by you guys to double check...

Thanks for the knowledge everyone . Im still a month or so out before I start on my system but I like to get as much info as I can before I start. Ill be asking you guys for more info in the near future.

Would this eKo Complete 4AWG Amp Kit from knukonceptz.com work for this Profile 400MSX 400W California Mono Sub, RMS (2 Ohms) 300W x 1?