Recent content by NTeg591

Okay, Im going to buy an L7 and 1200.1. I need a box for the L7. Anyone that has any experience with these, whats the best type of box for a hatchback? I wanna put one 12" L7 and a 1200.1 in my integra. Kicker says .88-2.0 cu ft. sealed box. and 1.75-3.25 cu ft for a ported box. i just need the...

Hey guys. Im tryin to build a hard hitting system. I was thinking Kicker for the subs and amps. I want to start with a 12L7 and eventually get another one. For the amp, I was thinking Kicker 800.2 It has 400W x 2channels @ 2 ohms, and the L7s have dual 2 ohm VC so Id just run them right to the...

Thanks dosia. But if my amp doesnt say its 2 ohm stable, is it safe to say it will be ok?

I have a 2 channel amp, but I was wondering if there was any way i could make it a 4 channel amp without drastically reducing the power output. Could i wire two pos. wires to one pos. terminal and same wit neg? thanks

I was thinking of getting the 10 inch Audiobahn DVC ( cant remember model # ) but it handles 600W RMS. I heard one and it sounds really good. But I was thinking of using the JBL 600.1 amp. Little brother to the sic 1200.1. it puts out 600 x 1 @ 2 ohms. Would this work? O $#!T, the subs are 6 ohm...

i was going single sub setup. i heard 15' don play as clean thats why i wanted 12's. was i BS'd again!?

DVC 4 ohms is 4 ohms on each coil. I was wondering the same about wiring each coil to its own channel. i was actually thinking of bridging em

Hey... I think i blew just channels one two four of my Legacy 1030. its 1000W 4 channel. its acting really weird. The only channel that works is 3. I had my RF z's bridged, then i wired them back to normal and it played for about an hour and quit. so i rearranged the wiring and only channel...

I also have a 1000W 4 channel Legacy amp. I was thinking of getting an HX2 (DVC) and bridging each coil. Could I do that? TIA

If you wire each coil to its own channel, you would be putting the amps 4 ohm rating to them. if you wire in parallel, youd be putting the 2 ohm rating to em. HTH

aluminum audiobahns eh? Thats a good choice, i guess, but i dont wanna have to buy another amp. are they DVC? if so, id only be putting 500 peak to each coil. how would that sound?

Sorry to bust in on your thread. but i picked up some Z's for a good deal until i can get some better ones. but anyway, my amp pushes 125x4 rms. 25 over RF's RMS rating. i have it bridged now and the gain way down. i was wondering if it would sound better if i put it back to 125 going to each...

Sorry to bust in on your thread, but i was wondering if the L7 would sound like $#!t if you put only 500 peak to each coil. They are DVC right? hmm. i just thought about that

Hey guys *and girls* Im new to this board, but been into car audio for a while. My current setup consists of... Sony CDA-650x HU 4-Infinity 652i 6.5's runnin off HU Now the rest... Legacy 1030 1000W amp... i kno i kno... 2-RF 2812 Punch Z subs... i kno i kno... My question is... I kno...