Recent content by Max_034

Thanks once again. My head unit didn't even last the year, I guess it was a bad one and since I didn't buy it from an authorized retailer it doesn't have a warranty. I already ordered a new one with extended warranty, not buying without a warranty anymore too many things have failed. Thanks for...

Thanks for the help, I was thinking along the same lines. After hearing it again I'm guessing it's the heads it since both the speakers and sub stop playing. Do you know how long should head units last? I live in California and the high temperatures rarely reach 100 during the summer. When the...

I don't know if this is the right place but I hope it is. So my problem. I installed a head unit with a monoblock amp and 2 subs. Everything was fine. About 3 months later I installed 4 aftermarket speakers and a 4 channel amp with new wiring. Everything worked fine for like 3 months and then 2...

Hello everyone, I recently installed a 4 channel amp along with 4 speakers in my car. I had previously installed a mono channel with 2 subs and that worked perfectly, however when I installed the 4 channel amp I can hear a, sometimes small, sometimes noticeable, static sound. Also at times the...

What do you mean? I'm sure that an EQ is used to process the sound level at different frequencies right? similar to a stereo EQ.

I have a basic 7 band equalizer, which I plan on keeping in the trunk. I want to control the bass with the epicenter control knob, which will be near the driver on the front. With that said what would be the best setup?

Hello, I'm planing on installing a 4 channel amp and speakers to my current system which consists of the head unit, mono amp, and subwoofers. However I also want to install an equalizer and an epicenter but I'm not sure how to wire them. Should I do 1. Head unit → Equalizer → 4 Ch. AMP...

In that case I'm guessing its best to get the 4ohm DVC and wire it to a total of 2ohm load, since it is easier to power it at 1000w rms. Right?

Ok a mono block it is. But is the sound quality dependent on the impedance of the sub and amp? Thanks for the quick reply.

Hello, I want to replace my current subwoofers with a single Type-R. The only thing is that I'm not sure which is the best option for me, the SWR-12D4 (4ohm DVC) or SWR-12 (2ohm DVC). I'm looking for clearest sound and not necessarily the loudest, but I would prefer a balance of the two. I'm...

Alright, thanks for the help. As for the fader Im not sure if my processor can control it but I don't really mind. Thanks for the help

Ok that sounds good. I already have an audio processor from an old system I think I will use that one. Also is the audio from the front and the rear the exact same? And for the splitters should I split at the head unit or near the amplifier, or it doesn't matter?

Ok here is my problem, I have an appradio 3 heads unit that only has four channel output. It has front right and left, and rear right and left or sub woofer output. Since I have already installed a subwoofer with a mono channel amp I want to know how I could install a four channel amp given that...