Recent content by Mascola222

It’s not the quality the volume is just really low compared to the drivers side

Both set to 0db

no I didn’t mess with anything at all yet correct me if this is untrue if it is a wiring issue the only logical issue has to be between the crossover and woofer I say this because the tweeter seem loud and crisp which means the input is fine and output to tweeter is fine am I correct in this...

I just installed my system and fired it up today front and rear speakers are on a 4 channel amp all speakers are working but my components in the passenger side has a lot of tweeter and very little mid is there something I’m missing both driver side and passenger are installed the same

Do you happen to know what the issue could be with the wire something I can look for?

I installed a pac rp4.2-hy12 vehicle specific for my 2012 Hyundai veloster I got it programmed and everything was good until I turn the car off then it doesn't work the next time I start the car the box gets the signal I know this cause the lights on the modul act as normal just does nothing...

I just got my pac audio rp4 and want to update it so I set the dip switches to on or down but it won’t connect to the app on my pc tried 2 micro usb cords is there anything I’m not doing that I should???

Sounds great thank you so much

Rms is 300w And I have 37x30x18 to work with I don’t want it huge but you can do as needed to get the 2.0

Hyundai Veloster Trunk is empty space is not an issue Infinity reference 1250w 12 inch sub Manufacture states min/max is 2.0 cu/ft Ported I listen to a wide Variety of music rap,metal,hip hop Just need something simple 3/4 mdf is what I would use

Just wondering if anyone has plans for a 2.0 cu/ft 12 inch sub box I’m a cabinet maker but little out of my realm any help would be greatly appreciated

Sorry wrong section

Just wondering if anyone has plans for a 2.0 cu/ft 12 inch sub box I’m a cabinet maker but little out of my realm any help would be greatly appreciated

I have a 2012 Hyundai Veloster I have pioneer 6 1/2 coax speakers in front and back and I left the factory tweeters in but now I’m ready to add subs amps and new aftermarket head unit should I just disco the tweeters or replace coax with components or if there’s any other options please feel...