Recent content by madmaxz

Still have?

for sealed FIq , RE SE , SE/x, IA LI, PG RSDC's

id12's would be a good choice

what size sealed enclosure for a 12" x or h

Need 2 12's for a sealed box. Box will be in the cab of truck. 1.0-1.5ft^3 per side.

**** nm just saw u gotz the 08. not sure then.

I have an 02 f250 crewcab and what i did is take the back seat out and moved the seat foward on the mounting brackets about 1.5-1.75 inches. pretty easy just had to drill 4 new holes where i wanted the seat to bolt to the bracket to move it foward. After that built a custom sealed box for 2...

REF-TM12.2 - Image Dynamics 12" Dual 2 Ohm OEM Tidal Audio Subwoofer * Nominal Impedance (IMP) 1/4 ohms * DC Resistance (Re) .98 / 3.8 ohms * Resonant Frequency (Fs) 20.7 Hz * Electrical "Q" (Qes) .412 * Mechanical "Q" (Qms) 3.80 * Total "Q" (Qts) .372 * Equivalent Volume (Vas) 5.71 cu...

same exact spec as the id12 at less then half the cost... hmmmm

id10 or idq10

again if people would just read.. 3" x 8.3 is image dynamics recommendation

well say you go with the ID spec box size of 1.5ft^3 tuned to 30hz. should 1 use Ids recommendation of 3" round at 8.3" long or winisds rec. of 3" x 13" or a 4"x21"

i did some research on this amp awhile back it should do close to rated power. i read a german article that tested it at 14xx watts at 4 ohms. suppose to be a really good amp i found 1 for around $250

u have to goto the parts store and get spray adhesive for like headliners or door panels.

bump