Recent content by m^ke

Mmmm, well my gains are quite low, prob just over a quater, i even think i have them a little to low, as the volume on my stereo turns up to more than 80% prob more like 92% mabe this could be the cause. ill have to have a play again. but thanks for the info. the tweets are wired the same on...

oh yes, the exact same thing. precision H236 6.5" with the extra mid-driver. a set was just the xovers with driver & tweeter, but my install guy got me the extra driver for the front & rear.

layman's terms please. haha

heres my setup... the front are helix precision H236 with a extra H236 mid-driver. thats 12" of midd-bass up front & in the rear. placed in the front doors, with the tweeter above & the other placed in my bmw`s stock kick well locations. heres my rear fill, i have used the...

i have 2 6.5" mids & a tweeter each side of my car up front, so thats 6 in total up front. heres a couple of pics. the top speaker is factory installed, in the door & thats disconnected. heres what it all looks like, but its a little dark, but you can just make out the 2X 6.5`s...

im trying to find a 4 channel 2ohm stable amplifier with 150rms to 200rms each channel. you think there is any ? as im trying to run just the one amplifier & not run two amplifiers.

dunno...

this is the problem i think, im not 100% sure my amps 2ohm stable? Technical Data: Power RMS / Musik at 4 x 4Ohm at 13,8 Volt 4 x 60/120 Watt Power RMS / Musik at 4 x 2Ohm at 13,8 Volt 4 x 100/200 Watt Power RMS/Musik 2 x 4 Ohm bridged 2 x 180/360 Watt it does say that on the spec, but...

take a look for your self. you see the 2 red jumpers on the xover? 1 is for the tweeter + & - other is for the dual driver setup, jumper for 4ohm & 2ohm. thats why i left the jumper on the 4ohm

how can this be if the xover is designed to run 2 mids in 4ohm, so the amp will only still see 4ohm.

yes, 4ohm, i can change the jumper on the xover to 2ohm, or leave the jumper on the 4ohm. Flexible 2-way frequency crossover with: tweeter level adjustment -3 / 0 / +3 dB with gold plated repositionable jumpers 4 ohm / 2 ohm switchable for the operation of two woofer systems integrated...

thats easier said than done, i have just spend at least 20 mins reading "how to set gains" & "amplifier settings" & they contradict themselves.... how do i set it up right then? & is it even possible to set right? as all types of music is different from each other, & the music...

no helix dark blue 4 http://www.audiotec-fischer.com/englisch/produkte/endstufen.html the components are also helix precision H236 the amp should be about correct for the speakers, the sound is awesome, midrange vibrates the car. when i play dia straits its sweet as a bell, but any other...

the reason im asking this is. i have recently gone from unamped 5.25" in-phase component speakers to amped dual 6.5" components. when i say dual, i mean, 4X 6.5" components, 2 to each xover. dont get me wrong, they sound nice, & the midrange couldnt be any better, but it just dont seem to...

i did the same to one of my speakers, i just put a drop of super glue on it. still works & sounds ok.