Recent content by llShakenBakell

ttt

Comparing these, which would best fit me: JBL MS62C- JBL MS62C * 6-1/2" 320W 2-Way MS Series Car Audio Component Speaker System * at Onlinecarstereo.com Alpine SPR-60C - Alpine SPR-60C 6.5" Type-R Component Car Speakers JBL GTO609C (3ohms so im guessing wouldnt work in my setup, right? Looks...

You think ill be able to bridge the Morels? 90 per side from the morels and my amp produces 150 per side. itll be pushing it very hard i know, good idea or should I keep searching? Thanks!

Yeah I know. bought a spacer to try to fit the ID ctx but then realized I needed an extra quarter inch to fit. Made a quarter inch mdf ring to put over the spacers and ended up finding out the door panel wouldnt fit even when I sanded down the door grill. All that work for nothing lol. I bought...

2009. Should be any depth under 2.5 would fit. Tried with a 2.75 but it was only a bit too big. Again looking for something that sounds similar to the ID ctx65cs. Or anything with great SQ

Yeah I know. Would've jumped on it if it fits into my setup. Any other recommendations? I checked sonic electronics but not sure what's good. Still new to the audio world

how would you suggest wiring it with alpine f300

So a friend has ID ctx65cs components and i loved the way they sounded. I tried to put those in my accord knowing that it will take some work to make it fit. Tried shaving down the grill on my door panel had a 1 inch spacer and everything to make the speakers fit. End up not fitting, so im...

Then its done. Thanks dude!

Dang. One for 100 and one for 120. I need a third opinion. Anyone?

What I was thinking as well, my sub is a bit lacking atm. 500watts is not enough lol. Planning to upgrade that up soon

Nope they're 4ga knu ofc wire. And upgrading to 0 real soon   ---------- Post added at 11:51 PM ---------- Previous post was at 11:50 PM ----------   Would 0 be overkill for current setup?   ---------- Post added at 11:52 PM ---------- Previous post was at 11:51 PM ----------  ...

Gotcha. I'll give it a go. Just wanted to make sure it's safe before I do anything.

Yeah. The fuses in the distro block will be 60 and 50. I found those already, but I can't find a 110 fuse for my inline. Should I go lower instead to a 100a? I've heard that you must run whatever that's listed on the amp, but I can't find anything that's rated at 110.

Bump