Recent content by kvar14

i am because thats a good example, however i still dont grasp how the tweeters which all basically have lower rms ratings than woofers dont get blown when youd like to be powering the woofer to its potential

did i ever tell you i love you jdawg

that 20 watt tweeter was just an extreme example, but what would you guys say would be a good speaker-loudspeker setup for a pa

almost seems like crossovers made for pas do control output to the tweeters Eminence pxb board-only crossovers are a lower cost alternative to the "cabinet ready" models and are targeted specifically for custom cabinet projects as they do not include the terminal cup, input connectors or L-pad...

so does that mean the max wattage you can input is governed by the lowest wattage speaker? or do you say get an 8 ohm tweeter and 6 ohm woofer to sorta balance out...i just dont get how the tweeter doesnt get killed trying to keep up with the woofer

lets say two but is the crossover the 1 keeping the watteage going to the tweeter low?? so they just sorta balance out and if so how can you tell if its a match pair like if youve got a 400 watt rms woofer and a 20 watt tweeter

Im gonna go alittle off the car stereo topic (while it still kinda is when looking at it from component speakers viewpoint) but anyways heres my question- Lets say im looking to make a pa now ive got a 500w 6-8 ohm stable amp. great. now this would be a 2 speakers setup, one mid-low range...

ok i got 2 12" type r's running off a brutus 1610d mono block and my components id say are recieving about 80 rms each from an a/b 125 crunch amp, now i have a stcok alternator and plan on doing the big three in the near future but will my battery be able to handle this crap, keeping in mind im...

anyone? bump

So i just got my 1600 brutus and was wondering how to properly wire my two 4dvc type rs for 1 ohm on this thing. the only part thats screwin with me is it has two sets of speaker terminals, --++ like so now do i just use 1 set or somehow incorporate both -Thanks

interesting every1 vs haunz!

Just because im curious, what setup would give you more loudness and which would give you a better overall sound. Lets use the example of 2-50 watt rms speakers at 4 ohms a piece vs one 100 watt rms speaker at 4 ohms, being of the same size and composition of materials

maybe i should go for this? BXi1608D Hifonics?

it says 6000 max so it seems a bit fishy, or if sombody can point me towards a amp that will take those subs to thier limits for around 250 bucks that d be great

my intentions are to upgrade my electrical i just got some material for the big three...50 ft of 1/0 knu wire