Recent content by jrobie79

Looking for suggestions on speaker placement for 3 way active setup front stage. I attached pictures of the doors, my proposed setup is to install everything in the doors. Nearly impossible to install the mid-bass in the kick panels as they are made for really shallow 5-1/4" speakers. The stock...

Looking for suggestions on midranges and tweeters for an active 3 way setup, as well as a small footprint amp for Anarchy 704s. I have a pioneer DEH-80PRS with a 12" Fi SSD running off a Memphis amp. Just picked up an RF 3sixty.3 so I'm looking for suggestions to round out the front stage...

Currently I have the PPI 356cs components in my car, however during my restoration the tweeters were knocked around and are pretty much useless now. Anyone have a recommendation on a good set to pair with the PPI 356cs woofers? I run it all in passive (not enough energy to set up an active...

Bump

Bump

bump

just found this information out: freq response: 60Hz - 22kHz sensitivity: 87db impedence: 4 ohms Fs: 65.96 Hz Re: 3.4 ohms Qms: 5.91 Qes: .65 Qts: .58 L1: .5 Vas (L): 7.38 Mms (Kg): .13 Cms: .437 Bl: 5.38 Xmax: .11328

I just emailed that epsilon electronics and they are turkeys over there too, basically told me they dont have parts for that set and they don't know the specs.

Yeah I swapped the good tweeter to the other side and it works fine, everything checks out aside from the tweeter itself, checked amp settings and head unit settings, its all equal so as far as I can tell its just the tweeter

do you know where I could find this info? i looked in the manual but dont see anything.....I emailed PPI but as usual there customer service *****, and I havent heard anything back

I have a set of the PPI 356cs and for what ever reason, cant figure it out, one of my tweeters **** the bed; other one works fine, wires have continuity, so w/e. I havent had much luck finding replacements specific to that set, so I was wondering if anyone had any recommendations of what I...

bump

Ttt

bumo