Recent content by jmcmahon

bones you mean like my uncle jim? lol, just kidding no relation

Do you mean on the actual motion sensor itself? I first turned the trigger zone sensitivity all the way down, then I started turning the warn away zone (which actually increases the size of both zones) up. The motion sensor itself has two lights on it, a red and a green light, that light up...

I have 3 JL audio 12w6 version 1 wired to 1 ohm (parallel voice and speakers) hooked up to a PG Ti800.1. I think my ground is good (I am going to check when I get off of work with my DMM), but it may not be. The bass eq on the amp is turned to -12db centered at 250Hz, and should not affect...

I recently installed a clifford 50.5x alarm/remote start. I also hooked up the add-on audio sensor. This was an easy connect with the included Y-plug that allows both the audio sensor and the shock sensor to be hooked into the shock sensor port. I also hooked up the add-on motion sensor. The...

Recently I installed the clifford 50.5x alarm/remote start. At first I connected everything except the accessory wire and ran tests on the system. I noticed everything worked except the accessories (AC, etc) did not work when remote started. I then connected the acessory wire and retested...

I have 3 JL 12W6s version 1. They are DVC 6 ohm and I have a Ti800.1 to power them. What do you guys suggest would be my best solution for wiring? I can do this two ways: 1) wire the subs in parallel with the voice coils in series, but then this would be a 4 ohm load to the amp. This would...