Recent content by JDay

I just installed it Wednesday but I haven't had any issues with it. I like the V20. It's been a great phone. Sent from my LG-H910 using Tapatalk

Buy a high-output alternator. You can add all the batteries and capacitors in the world but it doesn't do any good if your charging system cannot keep up. Alternators produce power, batteries and capacitors store it. Sent from my LG-H910 using Tapatalk

I have a 2001 Yukon XL 2500. When I got it the aftermarket system was not done right. I ran 12 gauge runs from the back, through the door grommets and used these for my door speakers, bypassing the factory speaker harness. Ripped out the 8 gauge CCA power and ground cables installed by the...

You should put some adhesive lined heat shrink on those terminations if you don't want corrosion. Sent from my LG-H910 using Tapatalk

And if that's the case it's time for a high-output alternator. Sent from my LG-H910 using Tapatalk

An inline fuse holder and a fuse are much cheaper than a trip to the ICU Burn Unit... or worse. There is no reason not to fuse it. Sent from my LG-H910 using Tapatalk

Excellent. I got the 370 amp for my 2001 Yukon XL 2500. Voltage rarely drops under 14.3v with my 2600 watt system going full tilt. Sent from my LG-H910 using Tapatalk

I got mine last week. From order to delivery was about 3 weeks. Sent from my LG-H910 using Tapatalk

That's for the power coming from your battery. I run 1/0 from there with a 300amp fuse into a distribution block. The 4 gauge runs going from the distribution block to my amps are fused at my amps rated draw. This is to protect the amps. The fuse at the battery is to keep your car from going up...

You turned your gain up too high and blew your speakers with a clipped signal. The gain is not a volume knob. It is for matching the input voltage on your amp with the output voltage from your head unit. Sent from my LG-H910 using Tapatalk

With an oscope. You can also but a DD-1 or DD-1+ and use that to set your gains. You could also get an AMM-1 to check for clipping in real-time. Sent from my LG-H910 using Tapatalk

I think you can buy RCA cables that have a ground lead if you want a cleaner install. You can always ground them behind your deck too.

Try grounding the RCA cable.