Recent content by gabrielpanoussi

Thanks!

Using 2 subs single coil 4 ohms each. My question is can i run the wires from the subs both to the terminals of the amp (fig 2) or should I run a pair from the amp to the first sub then a wire rom that sub to the second ( as seen in most traditional diagrams fig 1). Is it not electrically the...

I know, however if my player is my phone via blue tooth isn't the signal generated by my phone anyway? Yea it will get passed through the head unit and amplified for the full range speakers but how bad can it be?

I ended up returning the Boss and getting a Rockford Fosgate 500x1d. The head unit also a Boss which, I did not like will be exchanged for a blaupunkt clm100bt.

ouch! was that @4ohm?

kinda answered my own question. Short answer it is possible but not a good idea. I am going with 2x10's.

After toying with the idea of 2 10's vs 1 12 I thought has anyone done one 10 and one 12? I came across a deal on some subs I bought 2 10's and 2 12's. I also prefer to use sealed enclosures. So say a sealed stand alone SVC10 and a sealed stand alone SVC12 on a single class a/b mono block amp...

Thanks! I appreciate it.

So if my subs two single coil 4 ohm subs are wired in parallel do all channel sets need to be at 2 ohms as well. My deck has low ouputs for subs rear and front. So again if the sub output is going to be 2 ohms on my 2ohm stable amp do the front and rear full channel speakers need to be wired in...