Recent content by Frāmrāt

The amp has a lower subsonic adjustability starting at 10hz going up to 50 but no numbers or marks to indicate which frequency you're set to so it's a guessing game. The epicenter has a switch that shows exactly what frequency the subsonic is set to. The amp can go down to 10hz whereas the...

Thank you sir!!!

My subsonic filter on my amp has no on/off switch, it's just a dial like a gain dial. Should I turn it all the way down to 10hz since I'll be using subsonic on epicenter?

So turn the subsonic filter on the amplifier"off" or to it's highest setting?

Pic of epicenter

Here is my question....when using an epicenter with an active PFM subsonic filter(35hz, 50hz,80hz), should the subsonic filter on the amplifier match the subsonic filter on the epicenter? Should one or the other be set higher/lower than the other? The FS on my sub is 34.89hz. Ported box...12"...

Thank you so much for explaining!!! I've removed the ground fuses but I was just curious.

If the fuse is 150A on the "in" side and the "out" side, how does it add resistance? If I'm only letting in 150 amps and I'm letting out 150amps...where does the resistance come from?

I probably misunderstood. What are the negatives of having a fused ground? Will the amps no get full power?

I only fused the ground because I read an article that said fusing the ground with the same size fuse as used at battery on power wire, was just added security. I have since removed fuses.

Thank you everyone for your insight, honestly helps ALOT!! So in conclusion, it would be ok to also run one last item off of HU remote? Soundstream BX-10X epicenter?

When installing an epicenter like the Soundstream BX-10X , is it required to have the control Knob installed or can you still use the epicenter without installing the knob. I read somewhere that without the knob installed, the epicenter goes into a kind of bypass mode. Is this accurate? Any info...

You mean a on/off switch?

Ok, thank you!

Hello, I am a brand new member and as such I would like to show respect to all the other members by saying hello and it's nice to be a part of the group. I would also like to preface this post by saying I know this is a budget build but it is all I can afford right now, so please go easy on my...