Recent content by FenixAudio

You have to check voltage with a dmm. Looking @@ it won't tell u the issue. Make sure both reb and yellow are both getting voltage.and black is grounded well. Dual give some people fits. Be careful not to breal the harness.

So your getting power but no sound? Also, is the harness you used have 2 plugs or 1? If no power use a dmm to check voltage on yellow and red. Also make sure your ground is good. If power is good and no sound make sure u connect the blue/ white from the deck to the blue on the harness.

IWireless mod? Or wired? If wired I suggest the peripheral IS77. It has above average quality and ccan charge your I pod. If u don't mind me asking what kind of car?

Lic. Electrician does not = Certified car audio installer. And vice versa. All because u can talk ac voltage it doesn't act the same as dc especially in a car. Same laws different application. Your voltage drop of .2 volts is most likelly a loss of static charge. You should worry if you get a...

Or if your gnna run full pass just use the high level inputs if the amp has them.

Typically I woould agree with that, but he goooes into prrotect as soon as it turns on..usually if the amp turns off because of a ow impedence it will takke a whie to overheat and fail. I'm going to ay mmy mooney on the ampp having an issue internally.

If it was a fuse issue it wouldn't be in protect. take the sub off the amp and turn the ampp back on annd see if its in prootect. If the amp stays in protect without a load thhen you have an ammpp issue. If the light isn't in pretect then subs bad.

Agreed, makesure your amp can run @ 1 ohm...or it will turn off when it over heats

There is one wire that is multiplexed(veriable voltage) that controls the deck frfom the steering wheel. The jack comes with wireing diagrams, there show pin positions from the WIRE/PIN side of the harness. Also on the large table of cars the unit comes with it should have a wire color listed...

run a single and y adapt it if you want to but its all the same in the end.

A break down of the history of ohms law will make a good report. 3 sections can be currrent voltage and resistance.

if u have an alpine 900 it should turn down the audio automatically. If its badd move it. Get it as close to your mouth as possible. It would help to know the car your driving

Why not go with re shalows or even some cvt's? I would check out the kicker. IX1000p.1, bad *** amp..put like 4 in this week all sick..stupid loud

Should be a white wire. This will also help u get your power antenna to work also. Look and see if there are any loose white wires behind the deck, if everry thing else is hooked up there shuld only be a couple left. Use either blue white off the deck if u have one and if not use red.

the jeep set up was for a factory amp. are u using the rca's for sound? If so your module should have come with 2 adaptors for the input side of the module. One for bose and one for non bose, you will need to use the non bose and hook up speaker level(normal spkr wire from the main harness) to...