Recent content by Fender5

If this will work, I would definitely upgrade the speakers to something that will handle it.

i'm going to connect the power pack into the harnesses instead of my factory one. This is for a stock OEM radio. I would have to splice the factory one correct?

I want to install one of those Alpine or Clarion power packs behind my stock head unit. But what is the best way to install one without splicing into the factory wire? I was thinking about doing this: Amazon.com: Stereo Wire Harness OEM Toyota Tacoma 05 06 2005 2006 (car radio wiring...

From the outside heat or from the operating heat at 1 ohm?

Wtf. How did my Knukonceptz distribution block bend? I have 0 gauge in and a 4 gauge out 120A fuse. (3 40A)

So should I keep running it at 24 ohms? It sounds fine and still works good. The sound is more "full" I would say, since I have not had rear fill in a long time. I can hear the rear because it is louder. I am going to readjust the gains later, too **** hot. The tweeters up front are Dayton...

i went ahead and wired each speaker to its channel respectively. the rear deck is deadened, sounds great. Do you have any idea what ohm load I am running? Seleniums: 8 ohms each REs: 4 ohms each

i'm just trying to get all 4 speakers working. The seleniums are midbass. I have tweeters ran off the HU. I bought the 6X9s because I took the subs out. They sound great off the Crescendo. only speakers I have connected right now.

Could I bridge the 6x9s at 2 ohms. Then bridge the fronts at 4 ohms?

I guess I can deal with it by turning the gain on the 6X9s down some to balance the sound? Thanks for the advice

I have 2 Seleniums that are 8 ohms. I forgot about it when I bought these RE 6X9s, and they are 4 ohms. I have the 6x9s wired and the seleniums not hooked up because I am afraid of running it at the weird ohms. The Crescendo is not 1 ohm stable, but this is the only amp I am using in my system...

I've been thinking about this, and searching everywhere. Should I leave the amp settings at right over the intended crossover (100hz if I want the lpf at 80hz on the amp), and set the crossover at 80hz on the head unit? I feel like I am losing alot of my music by having the amp crossed at...

Does anyone have an extra HU mounting sleeve. I have a pioneer missing one. If you don't want it, I will gladly take it off your hands.

How bout the AQ Hdcs.

i forgot to mention I drive a 96 Honda Accord, always have done sub front, port in the middle. How did you like the sound of the 2510? The Z is discontinued, and i'd like to buy new for sure. I need a subwoofer that will go great with the AQ1200