Recent content by ed_rob

yes that is correct

So should i check my wiring to see if its wire wrong. I just notice that when i set my subwoofer on the head unit the subs goes off but when set off the subs goes on.

I set it on lpf at 60-80htz +3db bass boost. I dont have subsonic filter

Yea i had it lpf around 60-80 still sounds like a midbass.

They set it a lpf. What if i set it at hpf what happens?

Well the guys who install it at cc set the gains half way for boost , hpf at 45hz

well 250 watt speaker should be loud enough

sealed

its in an enclosure

I just installed my id12v3.2 into this amp http://www.partsexpress.com/pe/pshowdetl.cfm?&PartNumber=263-938&DID=7 wired in series and this subs is not thumping or playing to its potential. I had circuit city installed it for me and they say its the amp not putting much power to the subs...

I have the amp connected with good ground and rca cables connected what could be wrong.

If its not the fuse then what could it be because it seems theres no power to my subwoofer.

I think i have a blown fuse in my power wire or in my amp, I dont know but i had my power wire to connected to my amp but the amp was not connected yet. I install my amp today and no power to my subwoofer. What could be the problem.

I just got a id12v2 and want to get the most watts out of my amp. I want to bridged it in mono 4ohm load. How would i wire this. My amp specs are Power output: 75 watts RMS/125 watts max x 2 (4 ohm load), 125 watts RMS/200 watts max x 2 (2 ohm load), 250 watts rms/400 watts max x 1 (bridged...

what if ur running a single 12 2ohm do u still run it in series. Cause im doing a single sub setup.