Recent content by dj2606

it's 350.00 for the set i was hoping to keep this between 200-300 and hopefully closer to 2, however I may have to save up because those specs look crazy. However I will be forced upgrade the amp because they are rated at 180 rms. geeze that's crazy

are you using the CDT HD62 CF? http://www.arcaudio.com/pdfs/reviews/product-reviews/arcaudio-prod-reviews-9.01.pdf second page says 2.5" depth which would work.

87 views and no input.....

considering these WoofersEtc.com - FD6000 - ARC Audio 6.5" Component Set however I'm unsure of the mounting depth

so i'm lookin to replace my type r coaxial speakers with component speakers. the highs on them distort especially on the sssss's. So I would like to replace them with a good set of component speakers, the catch is I have a total of 2 5/8 allowable depth. I have a budget of 200 - 300 would prefer...

Quick question, can you run the 80prs in 3 way network mode with coaxial speakers? I ask because I tried, and my rear speakers are playing only highs. I want all component speakers to play mids and highs.

Not trying to hijack the thread, here is a pic of a ground from best buy. They used three screws and wedged them because the ring terminal diameter was too big. Instead of using one screw with a washer and lock washer. Also, the brownish part on one of the screws is where it was shorting to...

so just called them and spoke with the manager, he said the ground being loose wouldn't cause an amp to go into protection mode. Which I know is bs, because anything with a shorted ground or no ground connect will stop working. He also said that they normally wedge rivets on the ground because...

After they installed it and said that the gain had to be set low because the amp was way to much for the sub I popped in a 50hz tone cd and looped it, dialed the gain with my dmm to just under 28.28 volts and 3/4 HU volume. Not really sure how to describe the sound other than it's kinda farting...

I will post a picture of the ground terminal of the amp tomorrow when there is some daylight.

yep loose ground. The shop that installed it rigged the ground down with three screws because the ring terminal was 5/16 diameter. Do you think the sub could have blown because of this? When I got it to come back on it rattles, and doesn't really hit. Right now I have the rca unhooked to not...

**** guys, my bad I pulled info from wrong sub it's this one for sure. **** i feel retarted 10" Solo-Baric L3 Series Subwoofer RMS: 400 watts Enclosure impedance: 2 ohms (Wired internally in parallel to final 2 ohm impedance) High-temp dual 4 ohms voice coil

info from sonic electronic 10" Solo-Baric L3 Series Subwoofer RMS: 400 watts Enclosure impedance: 4 ohms (Wired internally in series to final 4 ohm impedance) High-temp dual 2 ohms voice coil Sensitivity: 85.3 dB

it's 2ohm

So my amp keeps going into protection mode. Amp Kicker mono 500.1 Sub Kicker - Solo-Baric L3 10" Single Ported I have a dmm and have checked all wiring and fuses are good. I have disconnected rca's and and sub speaker, the amp stays out of protection this way. It only goes into protection...