Recent content by Chris94L

What was your aversion to the AppRadio2? I was considering it with ARLiberator as most people seem to like that setup. Your input would be welcome.

replied to your pm just lmk so i can send paypal

Need input on where to put the tweeters for my component set in my 94 reg. cab F150. Have them mocked up right now, but can move them (will probably use the flush mount pod if room behind the panel allows for. Does this look like it will work well or can you see any other probable locations...

No room under the seat. The pan hugs the floor pretty well, and theres no room between the pan and the seats. Its a large amp.

I have 2 JL Audio 10w1v2 subs right now, probably want to reuse them. Here is the problem. I removed my seats and enclosure/amp to clean my carpets. In doing so I found that my enclosure had been water damaged. Pulled the back wall carpet off to find many holes in the sheet metal from...

voided warantee for removing a cover and pushing a push terminal? who told you that? How are you supposed to mount the crossover and/or make adjustments without taking off the cover?

get a screw in sidepost adapter that will make it into a terminal and bolt the cable to that?

I'm going to go ahead and assume that from the lack of response that there will be no issue with mounting my component crossovers to my subwoofer enclosure

I have a 94 F150 regular cab (read: small), I plan to put 2 10s behind the 40/20/40 bench seat. I will put the amp in the middle, an enclosure on either side. I was wondering if there would be any harm if I mounted my component crossovers to the outside walls of the enclosure, then just ran...

cool, they have alot of neat stuff on the knukoncepts website. Will probably order the kolossus kit with some extra sets of rca's, and I like the karma 12ga bi-wire speaker cable so will probably get some of that as well.

I have searched and not really found what I needed. I guess I need a power kit, and will purchase the RCA's seperately. I need a 4ga power and ground run, and 3 sets of RCA's. What will suit my needs best? And what kind of budget am I looking at spending? I don't want crap, but at the same...

+1

The installer I have used for all my alarm needs is about an hour away from me, and has always had it done quicker than they said (have had 4 installs done [1 alarm in mustang, 2 remote start add on in mustang, 3 alarm install in friends mustang, and 4 alarm and remote start from my old mustang...